MasterForce SM3051M Especificaciones descargar pdf (Pagina 16)

BevelScale indicators (Fig. 15)

1. When the blade is exactly 90o(0°) to the table,

loosen the bevel indicator screws (1) using a

#2 Phillips screwdriver.

2. Adjust bevel indicators (2) to the "0" mark (3) on

the bevel scab and retighten the screws.

Fig, 15

NOTE: View from left front of machine

45 ° Left Bevel Positive Stop Adjustment

(Fig. 16)

1. Set the miter angle to zero degrees. Fully

extend the sliding fence completely to the left

then pull the bevel detent pin (1) toward the

front of the machine. NOTE: When retracting

the bevel detent pin, it may be required to

shift the miter saw upper arm assembly to the

left/right.

2. Loosen the bevel lock handle (2) and tilt the

cutting arm completely to the left.

3. Using a combination square, check to see if

the blade is 45 ° to the table.

4. To adjust, tilt the cutting arm to zero degrees,

loosen the Iocknut (3) and turn the bolt (4) in

or out accordingly.

5. Tilt the cutting arm back to the left and

recheck alignment.

6. Repeat steps until the blade is 45 ° to the

table. Once alignment is achieved, tighten the

Iocknut (3) to secure the positive stop bolt.

45 ° Right Bevel Positive Stop Adjustment

(Fig. 17)

1. Set the miter angle to zero degrees. Fully

extend the sliding fence completely to the right

then pull the bevel detent pin (1) toward the

front of the machine. NOTE: When retracting

the bevel detent pin, it may be required to

shift the miter saw upper arm assembly to the

left/rig ht.

2. Loosen the bevel lock handle (2) and tilt the

cutting arm completely to the right.

3. Using a combination square, check to see if

the blade is 45 ° to the table.

4. To adjust, tilt the cutting arm to zero degrees,

loosen the Iocknut (3) and turn the bolt (4)in

or out accordingly.

5. Tilt the cutting arm back to the right and

recheck alignment.

6. Repeat steps until the blade is 45 ° to the

table. Once alignment is achieved, tighten the

Iocknut (3) to secure the positive stop bolt.

Fig, 17

NOTE: View from front of machine

33,9 ° Left & Right Bevel adjustment (Fig. 18)

1. Set the miter angle to zero degree. Fully

extend both sliding fences.

2. Loosen the bevel lock handle and tilt cutting

arm to the 33.9 ° left bevel positive stop by

pushing in on the bevel detent pin toward the

rear of the machine.

3. Using a combination square, check to see if

the blade is 33.9 ° to the table.

4. To adjust, turn the screw in or out with a

wrench (from the locations shown below)

until the blade is 33.9 ° to the table. (Fig. 18)

5. Repeat steps for the right bevel 33.9 ° bevel

adjustment.

NOTE: View from front of machine

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 37 38

Comentarios a estos manuales

Sin comentarios

MasterForce SM3051M Especificaciones Pagina 16

Comentarios a estos manuales