MasterForce SM3051M Especificaciones descargar pdf (Pagina 23)

SLiDiNG FENCE & REMOVE SLiDiNG FENCE

(FIG. 27)

Sliding Fence

CAUTION

The sliding fence must be extended when

making any bevel cut. Failure to extend the

sliding fence will not allow enough space for

the blade to pass through which could result

in serious injury. At extreme miter or bevel

angles the saw blade may also contact the

fence.

CAUTION

The right side sliding fence must be removed

when making any right bevel angle cuts

greater than 35oin combination with any

right hand miter angle. This fence must also

be removed whenever a 45 obevel angle is

desired with a miter angle greater than 22.5 °,

1,

2.

Unlock the fence cam locking lever (1) by

pushing it toward the rear of the machine.

Extend the fence (2) by sliding it out to match

the degree of the bevel cut. Lock the fence

cam locking lever by pushing it IN toward

the fence. NOTE: When transporting the

saw, always secure the sliding fence in the

collapsed position (toward the saw blade).

REMOVING OR iNSTALLiNG THE SLiDiNG

FENCE

Removing (Fig. 28)

1. Unlock the fence cam-locking lever by

pushing it out toward the rear of the machine.

2. Lift up on the sliding fence to remove it from

the saw.

Installing

1. Place the sliding fence onto the miter saw

fence aligning the nut (1) with the slot (4).

2. To lock the sliding fence, push the cam-locking

lever in toward the front of the machine.

_xj

= ,,b----4

SLIDING CARRIAGE SYSTEM (FIG. 29)

CAUTION

To reduce the risk of injury, return carriage

to the full rear position after each crosscut

operation.

1. For a chop cutting operations on small

workpieces, slide the switch head assembly

completely toward the rear of the unit and

tighten the carriage lock handle (1).

2. To cut wide boards up to 12-1/4 in., the

carriage lock handle should be loosened to

allow the switch head to slide freely.

Fig, 29

2 7

SLIDE CARRIAGE ADJUSTMENT (FIG. 29, 29=1)

CAUTION

For your own safety, never connect the plug

to power source outlet until all the adjustment

steps are complete and you have read and

understood the safety and operational

instructions.

1. Remove the slide cover (7) by loosening the

four screws (2), two on each side. (Fig. 29)

2. Loosen the two nuts (3) by using an open

end wrench (4). (Fig. 29-1)

NOTE: Do not remove the nuts (3), just loosen.

3. Slightly loosen the two screws (6) by using a

T-wrench (5). (Fig. 29-1)

4. Slide the saw on the rails, if the operation is

still tight, loosen the two screws more.

NOTE: Do not loosen the two screws too much.

5. Once you have the slide moving to the

desired feel, tighten the two nuts (3).

6. Replace the slide cover (7) and tighten the

four screws (2). (Fig. 29)

Fig. 29=1

23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 37 38

Comentarios a estos manuales

Sin comentarios