MasterForce SM3051M Especificaciones descargar pdf (Pagina 17)

Fig,18

For33.9°leftbevelpositivestop

adjustment,insertwrenchhere

.j._4

............. For 33.9 ° right bevel

positive stop adjustment,

insert wrench here

MITER ANGLE ADJUSTMENT (FIG. 19)

The sliding compound miter saw scale can be

easily read, showing miter angles from

O° to 45 ° to the left, and 0° to 45 ° to the right. The

miter saw table has nine of the most common

angle setttings with positive stops at O°, 15°,

22.5 °, 31.6 °, and 45 °. These positive stops

position the blade at the desired angle quickly

and accurately. Follow the process below for

quickest and most accurate adjustments.

1. Lift up on the miter quick lock (1) to unlock the

table.

2. Move the turntable while lifting up on the

positive stop locking lever (4) to align

the indicator (2) to the desired degree

measurement.

3. Lock the table into position by pressing down

on the miter quick lock (1).

Miter Scale indicator (Fig. 19)

1. Move the table to the 0° positive stop.

2. Loosen the screw (3) that holds the indicator

with a screwdriver.

3. Adjust the indicator (2) to the O° mark and

retighten screw.

ADJUSTING FENCE SQUARENESS (FIG. 20)

1. Loosen the four fence locking bolts (1).

2. Lower the cutting arm and lock in position.

3. Using a square (3), lay the heel of the square

against the blade and the ruler against the

fence (2) as shown.

4. Adjust the fence 90 ° to the blade and tighten

the four fence locking bolts.

CAUTION: If the saw has not been used

recently, recheck blade squareness to the

fence and readjust if needed.

5. After fence has been aligned, using a scrap

piece of wood, make a cut at 90° then check

squareness on the piece. Readjust if necessary.

Fig. 20

1

ii iJ

17

POSITIVE STOP MITER ANGLE ADJUSTMENT

(FIG. 21 )

1. Unlock the miter table by lifting up on the

quick-cam miter table lock (1).

2. While raising the positive stop locking lever

(2) up, grasp the miter handle and rotate the

miter table left or right to the desired angle.

3. Release the positive stop locking lever and

set the miter at the desired angle making

sure the lever snaps into place. NOTE: The

lever will only lock into place at one of the ten

positive stops.

4. Once angle is achieved, press down on the

quick-cam miter table lock (1).

Quick=cam Miter Table Lock Operation (Fig. 21)

If miter angles required are NOT one of the ten

positive stops noted above, the miter table can

be locked at any angle between these positive

stops by using the Miter Quick-Cam table lock.

1. Unlock the miter table by lifting up on the

miter quick-cam table lock (1).

2. While holding the positive stop locking lever

(2) up, grasp the miter handle and move the

miter table left or right to the desired angle.

3. Release the positive stop locking lever.

4. Press down on the Miter Quick-Cam locking

lever (1) until it locks the miter table in place.

NOTE: The miter Quick-Cam locking lever

should lock the table and prevent it from

moving. If adjustment is needed, see next step.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Comentarios a estos manuales

Sin comentarios